haier XQB60-C - Manual (Page 16)

Using process Using process Using process Using process
Procedure selection method
Times of pushing the
SELECT button
Selected procedure
Applicable circumstance
Contents (the lighted indicators
indicate the programs about to run)
WASH, RINSE, SPIN
When the common laundries need
washing, rinsing and spinning. WASH RINSE SPIN
WASH RINSE SPIN
WASH RINSE SPIN
WASH RINSE SPIN
WASH RINSE SPIN
WASH
(the washing liquid
remains in the tub)
Repeat using the washing liquid
WASH - RINSE
(the rinsing liquid
remains in the tub)
When prevent the laundries from
corrugating, and the laundries do
not need spinning
RINSE - SPIN
Spin
(spin after drain)
When the laundries need rinsing
and spinning after manual washing
When the laundries need only
spinning after manual washing
(first drain then spin)
Push the SELECT button for 5 times, and it will resume the initial mode. It will circulate in that sequence.
4.Switch the WATER LEVEL button to select suitable water level
5.Push the START/PAUSE button
5 Close the top lid. 6 The washing is finished.
It beeps to indicate the
finishing of washing
The power will be switched off automatically after the finishing of the washing.
If you open the top lid, the machine will stop working before spinning.
According to the capacity of the laundries, choose the three water levels High Middle Low
After the water inlet as per the preset water level, in case additional water quantity is required, please first set
the button to the
Reset when the automatic inlet reaches the water level, you can turn to the needed water
level.