Harbor Freight Tools 66187 - Manual (Page 4)

Page 4 For technical questions, please call 1-800-444-3353. Item 66187
Front Rack Installation
Note: The Front Rack is near the truck cab.
1. Slide Front Mounting Bracket (2)
over Front Base (4) as shown above.
Temporarily secure in place with Jam Bolt (D).
2. Place the Base/Bracket assembly as shown below
at the passenger side of the vehicle near the cab.
Loosen the Jam Bolt and allow the Base to slide
down so the foot rests flat on the truck bed.
3. Mark the bedrail at center of the holes,
3 holes in the side and 1 hole on the truck bed.
Any one of the 4 holes in the Base can be used
for the truck bed hole. Set the assembly aside.
4. Drill for and install 4 Blind Fasteners (H) in
the locations marked in the previous step.
5.
(Truck
Cab)
(Front
Bedrail)
(Passenger
Side Bedrail)
(Bed)
Attach the assembly to the Blind Fasteners as
shown above using Bolts (E), Washers (F),
and Spring Washers (G) - as shown above.
6. Insert Arm (6) into Frame (1) and secure
with Jam Bolt (D), as shown above.
7. Attach Ladder Stop (7) to Frame (1) using Carriage
Bolt (M), Washer (N), and Nylon Insert Nut (P).
8. Install Strap (8) through the bracket on the Frame (1).
9. Slide the assembled Frame (1)
into the Front Base (4).