Harbor Freight Tools 66187 - Manual (Page 3)

Page 3 For technical questions, please call 1-800-444-3353. Item 66187
Installation
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY DURING INSTALLATION:
Park truck in level, stable location well away from traffic.
Place transmission in park/neutral and set parking brake.
Note: For additional information regarding the parts listed in the following pages,
refer to Parts List and Diagram on page 7.
Blind Fasteners
Blind Fasteners will need to be installed
throughout these instructions.
To assemble Blind Fastener Installation Tool:
1. Slide Flat Washer (B) over Installation Bolt (A).
2. Place a box end wrench over
Unthreaded Installation Nut (C).
3. Place Installation Bolt through Unthreaded
Installation Nut, as shown.
A
B
C
Note: The Unthreaded
Installation Nut (C) is
used only to hold the
Blind Fastener (H) in place
while the Installation Bolt (A)
locks it in place.
To install a Blind Fastener:
1. WARNING! Verify that installation surface
has no hidden brake lines, wiring, or
other critical components before drilling.
Drill an 11 mm (0.433″) hole in the location
the Blind Fastener will be installed.
2. Thread the Blind Fastener (H) onto the Installation
Bolt (as part of installation tool) by hand until snug.
3. Insert Blind Fastener (as part of installation tool)
so that the flange rests on the lip of the hole.
4. Hold wrench attached to Unthreaded Installation Nut
still* while turning Installation Bolt clockwise
with another wrench until Blind Fastener is held
securely in place. When finished, unthread
Installation Bolt from Blind Fastener.
* Holding this Wrench still helps prevent the
Blind Fastener from turning with the Installation Bolt.
REV 12b
Step 3
Turn this
Bolt
Hold this
Wrench still
Step 4
H
Step 2