Hotpoint WT640 - Manual (Page 4)

4
GB
Unpacking
1. Using scissors, cut
carefully along one corner
post to remove the film.
2. Lift off the polystyrene
top cap and remove the
corner posts.
3. Carefully lay the left
side of the machine
down onto the top cap.
We recommend that a
second person helps to raise
and lower the machine.
Read these instructions carefully: the following
pages contain important information on installation
and suggestions on how the appliance works
4. Remove the
polystyrene base.
! This is the part of the
polystyrene base and
should have stayed intact
when you removed the
base.
! If it has broken off and
is still in the machine
remove it while the
machine is still laying on
its side on the top cap.
5. Stand the machine
upright.
We recommend that a
second person helps to
raise and lower the
machine.
! Continue to read the rest
of these instructions
carefully; the following
pages contain important
information on installation
and troubleshooting.
!
Protect the environment - please dispose of the
packaging material carefully and considerately.
Installation
IMPORTANT check
when unpacking your
machine: