beautypg.com

Polarized plug, Deluxe power nozzle, Check bag indicator – Hoover S3621 User Manual

Page 5: On-off switches, Floor surface selector, Handle positions, Carpet or rug cleaning, Hard surface floor cleaning

background image

Floor surface selector

Carpet or rug cleaning

When using the power nozzle for carpet
and rug cleaning, push the floor surface
selector button toward “RUG” (C). This
setting provides the suction and agitator
action necessary to deep clean carpets.
The nozzle adjusts automatically to vari-
ous carpet pile heights.

Deluxe power

nozzle

Handle positions

The handle has two positions when used
with the power nozzle: upright and
operating.

To lower handle to operating position,
place your foot firmly on the power noz-
zle and pull handle back.

Check bag indicator

The indicator will begin to show red as
bag fills with dirt. There are three condi-
tions that will cause the indicator to
become completely red:
1. The bag is full; change the bag.

2. Very fine materials (such as powder)
have been picked up, clogging the bag
pores; change the bag, even if it is not full.

3. There is a blockage in the nozzle, hose,
tools, or at the bag opening; remove the
blockage.

ON-OFF switches

After assembling cleaner, plug cord into
electrical outlet. Turn cleaner on by
depressing ON-OFF pedal (A). To turn
cleaner off, depress pedal again.

Note:

Pedal opposite ON-OFF pedal is

Cord Rewind Pedal (B).

5

2-2

Polarized plug

To reduce the risk of electric shock, this
appliance has a polarized plug (one
blade is wider than the other). This
plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to
install the proper outlet. Do not change
the plug in any way.

A

B

2-3

2-4

C

POWER

FLOOR

SURFACE

O

F

F

O

N

B

A

R

E

R

U

G

2-5

D

POWER

FLOOR

SURFACE

O

F

F

O

N

R

U

G

B

A

R

E

2-6

Hard surface floor cleaning

The power nozzle can be used for
cleaning hard surface floors such as
wood, linoleum, vinyl, asphalt and rub-
ber tile, sealed cork, concrete and ter-
razzo, as well as carpet.
To set the power nozzle for hard surface
floor cleaning, push the floor surface
selector button toward “BARE” (D). This
setting provides suction and no agitator
action. If you prefer, you may use the
hard floor tool to clean bare floors.
You will find it particularly convenient
when cleaning lightweight area rugs to
set the floor surface selector button on
“BARE” and continue cleaning the sur-
rounding floor surfaces.

Note

: The headlight will be ON in both

the “RUG” and “BARE” floor surface
modes

.