beautypg.com

Service, Lubrication, Powered hand tool belt replacement – Hoover S3621 User Manual

Page 12: Inspecting the belt, Replacing belt

background image

Service

To obtain approved HOOVER service and
genuine HOOVER parts, locate the near-
est

Hoover Factory Service Center or

Authorized Hoover Warranty Service
Dealer (Depot)

by:

• checking the Yellow Pages
under “Vacuum Cleaners -
Household” OR -

• checking the list of Factory
Service Centers provided
with this cleaner OR -

• checking the Service section of
The Hoover Company online at

www.hoover.com

OR -

• calling

1-800-944-9200

for an

automated referral of authorized
service outlet locations (U.S. only).

Please do not send your cleaner to The
Hoover Company in North Canton for ser-
vice, this will only result in delay.

If further assistance is needed, contact
The Hoover Company Consumer
Response Center, North Canton, Ohio
44720, Phone: 330-499-9499.

In Canada, contact Hoover Canada,
Burlington, Ontario L7R 4A8, Phone:
1-800-263-6376.

Always identify your cleaner by the

com-

plete

model number when requesting

information or ordering parts. (The model
number appears on the bottom of the
cleaner.)

Lubrication

The motor is equipped with two bear-
ings that contain sufficient lubrication for
the life of the motor. The addition of
lubricant could cause damage.

Therefore, do not add lubricant to
either motor bearing.

The agitator brush roll is equipped with
two ball bearings that should be lubri-
cated periodically by a Hoover Factory
Service Center or an authorized Hoover
Warranty Service Dealer (Depot).

Powered hand tool
Belt replacement

Inspecting the belt

The powered hand tool belt is designed
to last a long time and is not normally
replaced. However, if the belt is
cracked, gouged or broken, it should be
replaced.

12

3-27

3-28

3-29

The belt can be seen through the top of
the nozzle or by removing the bottom
plate and belt guard (Figs. 3-21 and 3-
22).

2. Grasp turbine (E) and pull firmly to
remove.
3. Remove belt from turbine pulley (F).
Replace with new belt.

Replacing belt

When replacing belt, ask for HOOVER

part no. 38528037.

1. Remove bottom plate, belt guard and
brush roll as described in Figs. 3-21
through 3-23.

4. With flat sides of turbine retainers (G)
pointing down, slide retainers into
grooves (H) on both sides of tool hous-
ing and snap into place.
5. Replace brush roll, belt guard, and
bottom plate as described in Figs. 3-23
through 3-26.

F

E

G

H