haier AP602AKEAA - Manual (Page 8)

LOW MID HIGH AUTO
Remote
controller
Remote
controller AUTO COOL DRY FAN HEAT
Operation
2 Press MODE button. For each press,
operation mode changes as follows:
4 Press FAN,For each press, operation mode
changes as follows:
Unit runs at the speed displayed on LCD.
When fan speed is AUTO,it is changed
automatically according to the indoor temperature.
Note:
During Auto run operation, temp. setting will be shown in LCD display, unit will select heating,
cooling or fan operation according to the room temp.
5
6
Select temp. button
Press TEMP button
Every time the button is pressed, temp.
setting increases 1 C
Every time the button is pressed, temp.
setting decreases 1 C
If the button is kept pressed, setting will
increase or decrease quickly.
3
In DRY mode, when room temp.becomes 2
o
C
higher than temp. setting,unit will run intermittently
at LOW speed regardless of FAN setting.
Ultra-low air flow
Temp.setting+2 C
Temp.setting
COOL operation starts when room
temp. is higher than temp. setting.
On reaching 2 C higher than temp.
setting,unit will run in mild DRY mode.
ON
OFF
TEMP
HEALTH FAN
MODE
SLEEP SWING
CLOCK
TIMER
SET
LOCK LIGHT RESET
HEAT
Then select AUTO run or select COOL
operation or select DRY operation or select
HEAT operation *
TEMP+
TEMP-
Press ON/OFF button Unit stops running.
Remote-control unit
Control panel
1 Press ON/OFF button
Unit starts running.
The previous status appears on the display
(except. TIMER, SLEEP mode)
Control panel
Part 1 to 4
bright periodically
Control
panel
AUTO COOL DRY FAN HEAT
LOW MID HIGH AUTO
1 2 2 1 2 2 3 3 1 2 2 3 3 4 4 1 2 2 3 3 4 4
ON/OFF MODE FAN
TEMP
TEMP+ TEMP- HEALTH