Wall mounting – Hitachi SBW100 User Manual

Page 7

Wall Mounting

The SBW100 system comes with a wall mounting kit to be used with a wall mounted TV. The input jacks and power cord are

designed to allow a flush mount where the Soundbar extends only 2” (50 mm) from the wall. Also, the Soundbar is provided

with an extra long power cord so the user may hide the AC line by using a wall track that could be painted to match the wall.

Follow these steps to mount the Soundbar on a wall:

1. Measure the width of the TV – the Soundbar

should be mounted so it is centered with the

TV. Divide the TV width measurement by 2 –

that will be the centerline distance from the

edges of the TV.

2. If the Soundbar is to be mounted below the

TV, measure from the TV edge to the

centerline distance on the open wall below

the TV. Mark the distance with a pencil

1-1/2“ (38 mm) or more below the bottom

of the TV.

3. Make a pencil mark 10-7/16” (265 mm) on

each side of the centerline. Make sure the

mark is the same distance down from the

TV on each side.

4. Make another mark 25/32“ (20 mm) directly

below the 1st mark on each side.

5. Drill a ¼” hole in the wall at each of the four pencil marks.

6. Hammer the 4 wall mount anchors into the holes -

the anchors should be flush with the wall.

7. Now, using a Philips screwdriver, screw the wall brackets in place

with the screws going into the anchors.

8. Tilting the bottom of the Soundbar slightly away from the wall, guide the brackets into the matching holes on the back of the

Soundbar. The Soundbar is now securely wall mounted.

[NOTES] The supplied mounting kit can be used for typical drywall construction. Mounting to wood, concrete, brick or other

types of wall construction will require different hardware. Hitachi recommends seeking professional assistance for

such installations.

The instructions on this page and the supplied wall mount kit are only for the vertical wall mount. Professional

assistance is required for other mounting or installation orientations (e.g., horizontal, tilted).

1-1/2”
or more

25/32”

10-7/16”

1. Find centerline

of TV.

2. Make a pencil mark

1-1/2” or more below

the bottom of TV.

3. Make a pencil mark on

each side of centerline.

4. Make another pencil mark on

each side of centerline.

X”

X/2”

1-1/2”

or more

10-7/16”

To Wall (Anchors)

Top