Hitachi SBW100 - Manual (Page 6)

6
Getting Started
Table Top Style
You can set the Soundbar on the cabinet that is properly
designed to place the Soundbar and the TV. Please install
the supplied stands by following the instruction that is shown
on the bottom of this page. You can place the Subwoofer on
the floor.
Determine how you want to set up your Soundbar and Wireless Subwoofer Audio System.
The following figures show 2 (two) typical installation styles. One is the Table Top style and the other is the Wall Mount style.
Wall Mount Style
You can mount the Soundbar on a wall by using the supplied
hardware kit. The input jacks and power cord are designed to
allow a flush mount. Please follow the instructions that are
shown on page 7 of this Owners Guide. You can place the
Subwoofer on the floor.
Location
Select an area where sunlight will not fall directly on the products. Also, be sure that the location selected allows a free flow of air to and
from the products. In order to prevent an internal temperature increase, maintain the following space requirements.
Soundbar
Top / Bottom / Back: No clearance required - can be flush mounted.
Left / Right: At least 6” (150 mm) clearance required.
Front: Open between the Soundbar and the listeners.
Subwoofer
Top / Back / Left / Right: At least 2” (50 mm) clearance required.
Front: Open between the Soundbar and the listeners.
The wireless range of your SBW100 is up to 100 feet, but it may vary depending on your operating environment.
Installing the stands
In order to place the Soundbar on the cabinet or the shelf, you need to install the supplied 2 (two) stands by using the following installation
guide. Please make sure that the cabinet or the shelf is strong enough and well secured.
Step 1
Insert the top tab of the stand
into the hole provided for the
stand in the back of the
Soundbar.
Step 2
Make sure that the top
tab is fully inserted into
the hole.
Step 3
Swing down the stand all
the way until the stand hits
the Soudbar so that the
base of the stand will be
underneath of the bottom
of the Soundbar. Then
push up the stand to fit the
Soundbar.
Step 4
Make sure that the both stands are
installed as shown in the above
picture.