Hitachi SBW100 - Manual (Page 11)

Wireless Link
11
PAIRING Button
PAIRING Button
Wireless Link
The Soundbar and Subwoofer should automatically link together. However, it is sometimes possible, in conditions of very high radio
interference (such as from microwave ovens or strong wireless network equipment), for the Soundbar and the Subwoofer to lose their
wireless link. In that case the Subwoofer will mute and the audio will sound weak (no bass).
To correct this, press and hold the PAIRING button on the back of the Soundbar at least 3 seconds until the PAIR indicator on the front
panel starts flashing.
Then go to the back of the Subwoofer and press its PAIRING button. The two units should link back up and the PAIR indicator on the
Subwoofer turns on.
The PAIR indicator on the Soundbar will turn off, after the link between the Soundbar and the Subwoofer is established.
PAIR Indicator
[Note] You can leave the Subwoofer on – it will go into a low power consumption mode when not in use but will wake up automatically
when a signal is present.
PAIR Indicator
Back of Soundbar Soundbar Front Panel Controls / LED Indicators
Back of Subwoofer
Subwoofer Back Panel