How to fill the detergent dispenser, Washing dishes, Detergent – haier DW15-PFE S User Manual
Page 17: Loading the detergent, Programme selection, Earn savings, Programme data, Switching the dishwasher on, Turbisensor
15
Detergent
Detergent specifically intended for use with dishwashers
must be used. The dispenser must be refilled before the start
of each wash cycle following the instructions provided in the
"Programme overview". The detergent dispenser is located
on the inside panel of the door.
Notice:
To facilitate closing the cover, remove any excess detergent on
the edges of the dispenser.
6
5
To open the " 5" cover on the dispenser, press the "6"
button.
The detergent for the wash cycle should be poured into
the " 7" compartment.
The detergent for the pre-wash cycle should be poured
into the “ 8” compartment.
After the detergent has been placed in the dispenser,
close the cover and press down until it clicks in place.
7
8
How to fill the detergent dispenser
Loading the detergent
18
Washing dishes
Programme selection
The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as
well as the amount and condition of food remains, with the details contained in the wash cycle table.The
corresponding programme sequence, duration and consumption details are shown in the right half of the
overview. For example:
Use the “Normal Wash” programme for dishes and utensils which have plenty of food remains stuck
on hard.
Earn savings
If only a small number of dishes have been loaded into the dishwasher,selecting a programme that
operates at the next lowest temperature will usually be sufficient.
Programme data
The stated programme data are based on standard operating conditions. The values can vary consider-
ably according to:
different amounts of dishes
temperature of mains water supply
pressure of mains water supply
ambient temperature
fluctuations in mains voltage
machine-related factors (e.g. temperature, water volume,...)
Energy and water consumption is reduced by up to 1/4 when dishes are washed in the upper basket
only.The water consumption values are related to water hardness level 1.
Switching the dishwasher ON
Turn on the tap.
Set ON-OFF Button “ A ” to ON. Programme indicator “ 9 ” lights , time-remaining indicator “10”
displays the time of programme and cycle phase indicator “ 11 ” lights up, too.
Turbisensor
G
GG
GG
*
on applicable models
The Turbisensor ia an optical measuring device with which the cloudiness of the water in the dishwasher
is measured. A photoelectric sensor is used to detect the degree of soiling in the water, caused by
dissolved food particals such as egg, fat and rolled oats, etc.