beautypg.com

Rinse aid, Loading the rinse aid, Cancelling or modifying a cycle – haier DW15-PFE S User Manual

Page 13: Programme cycle progress indicator, 1/2 load button

background image

11

It is recommended that adjustments be made in accordance with the following table:

Rinse aid

This product makes dishes sparkle and helps them to dry

without spotting. The dispenser is located on the inside panel

of the door and should be filled after low rinse aid indicator

2 ” lights.

Loading the rinse aid

Regardless of the type of detergent dispenser installed on

your appliance, you must proceed as indicated below when

loading the rinse aid.

To open the dispenser, turn the " 3 " cap in an anti-clock-

wise direction and then pour in the rinse aid, making sure

not to overfill. The amount of rinse aid used for each cycle

can be regulated by turning the "4" dose adjustor, located

beneath the "3" cap, with a screwdriver. There are 6 differ-

ent settings; the normal dosage setting is 3.

3

4

2

Water Hardness

Clarke

degrees

º

dH

mmol/l

Selector

position

Salt

c o n s u m p t i o n

(Grams/cycle)

Autonomy
(cycles/2kg)

0

14

M

NT

M

NIT

NIU

QIQ

NU

QQ

NQ

PS

PS

TN

QR

UV

QIR

UIV

[UV

[TN

[UIV

L

=?J?

jba

L

M

OM

QM

SM

?H?

SM

QM

OR

Level

1

2

3

4

Important

Proper dosage of the rinse aid improves drying.

If drops of water remain on the dishes or spotting occurs, the dosage adjus-

tor should be turned to a higher setting.

If the dishes have white streaks, turn the dosage adjustor to a lower setting.

22

Cancelling or modifying a cycle

A cycle that is underway can be modified if it has only

been running for a short time. Otherwise, the detergent

may have already been used, and the appliance may

have already drained the wash water. If this is the case,

the detergent dispenser must be refilled ( see the para-

graph entitled, “ Loading the detergent ”).

To modify a cycle that is already underway, press the

button“ A ” , all of the settings will be cancelled. To set a

new cycle, follow the instructions contained in the para-

graph entitled “Switching the dishwasher ON”.

Programme cycle progress indicator

The dishwasher is equipped with a LCD screen “ 11

that lights when the appliance is switched on by his light

itself.

From left to right, the phases in the cycle are: prewash,

wash, rinse and dry ( indicator 3 ).

During every phase of the wash cycle, the correspond-

ing indicator blinks. At the end of the programme, there

is a beep and the screen light will go out.

1/2 Load Button

This button E (see" Close-up View(Control Panel) ", letter " E ") makes it possible to wash dishes using

only the upper rack or the bottom rack if there are not enough dishes for a full load. This will allow you to

save on water and energy consumption.

Select the programme ( see the paragraph entitled“ Switching the dishwasher ON”)

Press the 1/2 load button “ E ” , upper 1/2 load indicator “ 14 ” lights on.

Press the start button“ D ” .

Close the door.

To select the upper 1/2 load:

A

11

This manual is related to the following products: