Hunter Fan 44360 - Manual (Page 15)

15
4. remove the wall plate and drill two 3/16” holes where marked.
5. Tap the plastic anchors into the holes until they are flush with the
wall. (Do not use plastic anchors if you encounter a stud in the
wall.)
6. reposition the wall plate on the wall, pulling the wires through
the opening. Insert the mounting screws through the wall plate
and into the anchors. Verify that the wall plate is visually level
and securely tighten both screws.
InSTAllInG THE THErMOSTAT, COnT.