HP 2995 - Manual (Page 4)

4
PRODUCT SPECIFICATIONS
ABOUT THIS PRODUCT - Bodine’s PACESETTER
TM “NEMA 4” series
inverter is designed to provide variable speed control of standard three-
phase AC induction motors. Adjustable linear acceleration and
deceleration are provided, making the drive suitable for soft start
applications. The output voltage is sinewave coded PWM operating at 16
kHz, which provides high motor torque, high efficiency, and low noise.
The full featured drive is easy to install and operate. Simple trimpot
adjustments eliminate the computer-like programming required on other
drives. However, for most applications, no adjustments are necessary.
Table 1 – Electrical Ratings
Input Volts 115 or 230 VAC +/- 10%, Single Phase, 50/60Hz
Input Current 11.0 (115V) or 7.0 (230V) Amps AC
Output Volts 0 – 230 VAC, Three Phase
Output Current, per Phase 2.4 Amps RMS
Maximum Motor HP (kW) ½ HP (0.37 kW)
Table 2 - General Performance Specifications
Parameter Specification Factory
Setting
Maximum Load 150% Current Overload for 2 Minutes -
Switching Frequency at Motor 16 kHz -
Signal Following Input Voltage 0 – 5 VDC -
Signal Following Input Resolution 8 bits -
Minimum Speed Trimpot Range 0 – 40% of frequency setting 0
Output Frequency Setting 50 Hz, 60 Hz, or 120 Hz 60
Maximum Speed Trimpot Range 70 – 110% of frequency setting 100
Speed Range 50:1 -
Acceleration Trimpot Range .3 – 20 seconds 1.0
Deceleration Trimpot Range .3 – 20 seconds 1.0
Boost Trimpot Range (50Hz only) 6 – 30% -
Slip Compensation Trimpot
Range 0 – 3 Volts/Hz/Amp 1.5
Current Limit Trimpot Range 1.5 – 4.5 Amps AC 3.8
Speed Regulation (0 to Full Load,
30:1 Speed Range) 2.5% of Base Speed -
Operating Temperature Range 0 to +40 O C -
Overload Protector Trip Time
(Stalled Motor) 6 seconds -
Bus Overvoltage Trip Point 400 VDC (283 VAC Line Volts)
Bus Undervoltage Trip Point 260 VDC (184 VAC Line Volts)