Hitachi 42PD5000 - Manual (Page 58)

Be sure to insert the speaker cables securely.
Lock the connection terminal level securely.
Caution required
Caution
Make sure the monitor power is switched off (with the standby/ receive lamp switched off or red)
before you connect or disconnect the speaker cables.
Attach the speaker systems to the monitor.
1
2
Attach the speaker brackets to the speaker systems.
Attach the screws in a position that allows you to read the speaker holder orientation markers (R), (L).
screw X 2
screw X 2
Speaker holder
Speaker
holder
(R) In the case of (R) (L)
Cushion
L
R
SPEAKER TERMINAL (8 Ω8W)
Loosen
screws
Monitor rear side
Hook this section
on the loosened
screw
Speaker holder
shown the other side
Remove
screws
Remove
screws
Ω
Right side Remove two screws on each side of the monitor
as shown and keep them for re-install. Loosen
two screws on each side of the monitor as
shown so that the speaker holders can be slide
on to them. Insert the loosened screws into the
engaging holes of the speaker holders that are
attached to the speaker system, and slide the
screws downwards. Next, use the previously-
removed screws to fasten the speaker holders
into the mounting holes in the monitor. Tighten
the four screws to secure.
Attach the speaker systems to the monitor.
3 4 Attach the connection cables to
the speaker system.
Connect the copper-coloured
wire to the side
Connect the silver-coloured
wire to the side
Speaker terminals
+
-
Press down
the lever with
your finger Remove
your finger Insert the
wire
How to connect
the speaker
cables
(Speaker side)
Pull off while twisting
Please prepare the supplied
speaker cables.
Treating the wire ends
Attach the speaker connection
cables to the monitor.
Ω Ω
Black Red
Connect
the copper-
colour wire
Connect
the silver-
colour wire
Ω
+ -
How to connect
the speaker
cables
(Monitor side)
Press the
lever down Raise the
lever Insert the
wire
Use of cushions
In some cases, there can
be a gap between the main
unit and the speaker. You
can attach the cushions
provided to the side of the
speaker system, if desired,
to eliminate the gap.
Attach the cushions
to the sides of the
speakers facing the
main unit.
Cushion
Align the cushions
to the front of the
back case and affix
them.
Back case
Notice