Hitachi 42PD5000 - Manual (Page 31)

ENGLISH
Optional Video Unit Function
Additional functions when the optional video unit is installed are as follows: ( )
Use if the
video
equipment
has an
S video
input terminal
To
S video output ter
minal
To
audio output ter
minals To
audio output ter
minals To
component output ter
minals
To
component output ter
minals
To
component input ter
minals
To
component input ter
minals
To
composite input ter
minal
To
audio output ter
minals
To
audio input ter
minals
20 18 16 14 12 10 8 6 4 2
21 19 17 15 13 11 9 7 5 3 1
VTR
VTR
DVD player Set-Top Box
Video disc player
Adaptor
To
composite output ter
minal
S-video/Composite video
Do not connect both
plugs at the same time.
Use either of them.
S-video can not
be used.
Adaptor
with Cable
(32") (42")
(1) Make sure that the power switch of the monitor is turned off.
(2) Make sure that the power switch of the imaging device is turned off.
(3) Use a commercially available cable and connector to connect the signal input terminal on the rear panel of this
device and the signal output terminal of the imaging device.
INSTALLATION INSTRUCTIONS
Connecting to a Video Imaging Device
• If video equipment with an S video output terminal is used, cabling
by the S video cable is recommended to provide finer video
quality. (If an S video input terminal and a video input terminal of
AV3 connect to the monitor at the same time, S video input would
govern.)
• If the OUTPUT (MONITOR) terminal is connected to an external
monitor with a 75 Ohm terminal, it is possible to view the same
image as on the main unit. But it is possible to monitor only the
composite video signal from AV1, AV2, AV3 or AV4 input that is
displayed on the screen at the time.
• If the adaptor is applied to AV4 input as shown in the drawing, it is
not possible to receive RGB signal.
With RGB component setup
To component video
equipments.
Please use the connection
cable suitable for the terminal
form of video equipment.
[An example of connecting video imaging devices]
Applicable video signals for each input terminal (See PRODUCT SPECIFICATIONS for details. )
Terminal RCA/SCART DVI D-sub Remarks
Signal CVBS S-video Component RGB PC STB RGB Component
AV1
AV2 Refer to Setup Menu.
AV3
AV4 Refer to Setup Menu.
RGB1 Refer to Setup Menu.
RGB2 Refer to Setup Menu.
(
Monitor rear panel Speaker (R) Speaker (L)
Power
cord