Hughes Direcway DW6000 - Manual (Page 165)

Appendix E • Installing DVADB
1033295-0001 Revision 2
131
Configure software Remember you must commission the DW6002 before you can set
up the VADB modem.
1. Open the User Interface.
2. Click
System Information .
3. Verify the software release number is 4.2.0.7 or above. If it is
not, contact installer support to make sure the correct
software is downloaded to the unit.
4. Use a browser to open the Advanced pages. Type the URL for
the DW6002 User Interface and add
/fs/advanced/advanced.html and press Enter . The
Advanced pages interface appears. See Figure 124. (You can
also type
www.direcwaysupport.com/fs/advanced/advanced.
html ).
5. From the right most drop-down box, select
vadb_config_show() . See Figure 125.
6. Verify vadb_net_enabled and vadb_rem_enabled are both
set to ENABLED. If they are not, contact the NOC and
request the values be updated.
Figure 124: Advanced pages