Hawking Technology Wireless-G Router - Manual (Page 49)

Advanced Administration
Wireless Station Configuration
This section applies to all Wireless stations wishing to use the Wireless Router's Ac-
cess Point, regardless of the operating system which is used on the client.
To use the Wireless Access Point in the Wireless Router, each Wireless Station must
have compatible settings, as follows:
Mode The mode must be set to Infrastructure.
SSID (ESSID) This must match the value used on the Wireless Router. The default
value is Untitled
Note! The SSID is case sensitive.
WEP By default, WEP on the Wireless Router is disabled.
•
If WEP remains disabled on the Wireless Router, all stations
must have WEP disabled.
•
If WEP is enabled on the Wireless Router, each station must
use the same settings as the Wireless Router.
Note:
By default, the Wireless Router will allow both 802.11b and 802.11g connections.