Huffy SKM 5200 - Manual (Page 6)

6 P/N 205932 5/99
25
14
17
15
16
20
19
27
23
23
28
25
26
16
IMPORTANT! Test fit bolts into
holes of brackets (14) and carefully
rock them in a circular motion to
ream out paint from holes if
necessary.
IMPORTANT! Finger tighten nuts
and bolts until instructed to fully
tighten later.
Fit spacer (17) into pawl and fit pin
of pawl through end slot of release
lever (19).
IMPORTANT! Bolt (24) must be inserted through tube (23), spacer (25), support bracket (16), board bracket
(14), release lever (19), wave washer (26), and then ratchet (27). Fully tighten all nuts and bolts after assembly.
Use pliers to stretch spring (29) into position.
19
13.
14
16
21
24
29
18
22
9.
10.
11.
12.
13.