Harman-Kardon AVR 110 - Manual (Page 2)

2 TABLE OF CONTENTS
3 Introduction
4 Safety Information
4 Unpacking
5 Front Panel Controls
7 Front Panel Information Display
9 Rear Panel Connections
11 Remote Control Functions
14 Installation and Connections
16 System Configuration
16 Speaker Placement
17 System Setup
17 Speaker Configuration
18 Output Level Adjustment
19 Delay Settings
21 Operation
21 Basic Operation
21 Source Selection
22 Surround Mode Chart
23 Surround Mode Selection
23 Digital Audio Playback
23 Selecting a Digital Source
25 Tuner Operation
26 Tape Recording
26 Output Level Trim Adjustment
26 Display Brightness
27 Programming the Remote
27 Direct Code Entry
27 Auto Search Method
27 Code Readout
28 Macro Programming
28 Programmed Device Functions
29 Volume Punch-Through
29 Channel Control Punch-Through
29 Transport Control Punch-Through
30 Reassigning Device Control
Selectors
31 Function List
33 Setup Code Tables
43 Troubleshooting Guide
43 Processor Reset
44 Technical Specifications
AVR 110 Audio/Video Receiver
Typographical Conventions
In order to help you use this manual with the remote control, front panel controls and rear panel
connections, certain conventions have been used.
EXAMPLE – (bold type) indicates a specific remote control or front panel button, or rear panel
connection jack
EXAMPLE – (OCR type) indicates a message that is visible on the front panel information display
EXAMPLE – (outlined type) indicates a lit indicator in the front panel information display
1 – (number in a square) indicates a specific front panel control
¡ – (number in a circle) indicates a rear panel connection
a – (number in an oval) indicates a button or indicator on the remote
A – (letter in a square) indicates an indicator in the front panel display