Harbor Freight Tools 97719 - Manual (Page 9)

Page 9 SKU 97719 For technical questions, please call 1-800-444-3353.
SpECiFiCAtiOnS
Electrical
Requirements
240 V~ / 60 Hz / Single Phase
Power Plug Type:
240 Volt, 3-Prong, Grounded
(Not Included)
Output Current
AC 55 - 135A
DC 30 - 105A
Max. Input
Current
40 Amps Operating
Indicators
Power On Light (Green)
Thermal Overload Light (Orange)
Welding
Capacity
Thickness
Up to 1/4” (using 1/16”, 3/32” or 1/8”
diameter electrodes)
Duty Cycle
10% @ 130 Amps AC
15% @ 100 Amps DC
Load Voltage
25.2V (AC operation)
24.2V (DC operation)
Open Circuit
Voltage
68V (AC operation)
60V (DC operation)
Accessories
Welding Shield (Qty. 1)
Hammer/Brush (Qty. 1)
Electrode Holder (Qty. 1)
Ground Clamp (Qty. 1)
unpACking
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please call
Harbor Freight Tools at the number shown
on the cover of this manual as soon as
possible.
initiAL SEt up
inStRuCtiOnS
Read the EntiRE impORtAnt
SAFEtY inFORmAtiOn section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
tO pREVEnt
SERiOuS
injuRY FROm ACCiDEntAL
OpERAtiOn:
turn the power Switch of
the Arc Welder to its “OFF”
position and unplug the
tool from its electrical outlet
before assembling or making
any adjustments.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Assembly
To assemble the Welding Shield, 1.
place the Shield on a flat surface.
Press the Handle into place. Then
insert the Filter Lens.
(See Figure A.)
This Welder requires the attachment 2.
and use of a UL-listed, 240 volt,
grounded, 3-prong, electrical Power
Cord Plug (not included). Only a
quali fied electrician should install the
FiguRE A
REV 09d; 09l