Honeywell 11280S - Manual (Page 11)

61-86-03-13
Page 11
Model Selection Guide, continued
01128_ _
4S
5S
6S
8S
TABLE V - SWITCH AND RELAY OUTPUTS (2 mech end-of-travel limits standard) Selection 9S 7S
Auxiliary Switches None
and 2 Aux. SPDT Switches
2 Aux. + 2 Programmable Relay Outputs
2 Programmable Relay Outputs
4 Programmable Relay Outputs
Auto/Manual Switch None
One Auto/Manual Switch with Out-of-Auto Contact
TABLE VI - CONFIGURATION INTERFACE
Remote
None 0
Local Integrally mounted local display/keypad interface 1
TABLE VII - COMMUNICATIONS/PROTOCOL
Modbus RTU RS485
RS-485 Modbus compliant - standard with EEU 0
Additional Communications Future 1
TABLE VIII - OPTIONS
Crank Arm
Adjustable 8" to 14" Radii - Standard 0_ _ _ _ _
None 1_ _ _ _ _
Linkage Kit None _0_ _ _ _
Up to 20 ft. length - customer supplies schedule 40 pipe _1_ _ _ _
Future Option None _ _0_ _ _
Future Option None _ _ _0_ _
Tagging None _ _ _ _0_
Linen (Note 3) _ _ _ _1_
Stainless Steel (Note 3) _ _ _ _2_
Future Option None _ _ _ _ _0
TABLE IX - FACTORY OPTIONS
Motor Orientation
None 00
RESTRICTIONS
Restriction
Available Only With Not Available With
Letter Table Selection Table Selection
a I 11284S, 11285S, 11286S I 11287S, 11288S, 11289S
Note 1: Requires (2) adapters PN 51204694-501 for retrofit of existing Leeds & Northrup 011284 and 011285 actuators.
Note 2: Slidewire emulation is a solid state circuit providing a ratiometric voltage output proportional to shaft position.
Note 3: Customer must supply tagging information: Up to 3 lines (22 characters for each line)
_ _0
_ _1
04 _
22 _
02 _
00 _
20 _