HP CC330 - Manual (Page 37)

3 3 3 3
Transmission
Video System
Use this setting to determine your video system in the current area.
1. Select the Video System in Connection Setup menu.
2. Use the Up/Down navigation buttons to select NTSC or PAL.
Then press the button to confirm.
The video output signal can be switched to NTSC or PAL to
accommodate different regional standards. The appropriate setting
will vary between regions.
NTSC USA, Canada, Taiwan, Japan, etc.
PAL Europe, Asia (excluding Taiwan), Oceania, etc.
Note: The TV output will not display properly if an incorrect video system is selected.
Connecting to a PC
Use the USB cable and ArcSoft software (CD-ROM) supplied with your camera to copy (transfer) pictures to a
computer.
Setting the USB mode
Since the camera’s USB port can be set to connect with either a PC
or a Printer, the following steps will allow you to ensure that the
camera is correctly configured to connect with a PC.
1. Go to the camera setting menu, select USB connection with the
Up/Down button, and press the Right button.
2. Use the Up/Down navigation buttons to select PC.
3. Press the button to confirm the setting.
Transferring photos and videos to your PC
If your computer or Laptop has a SD/SDHC card reader, it is easier to transfer photos and videos from the camera's
memory card directly. However, if your system does not have a SD/SDHC card reader, you can use the USB
connection between the camera and computer/Laptop.
The computer will automatically detect the camera as a removable drive. Double-click
My Computer icon on the
desktop to locate the removable drive and to copy the folders and files in the drive to a directory on your PC as you
would copy any typical folder or file.
By using the USB cable, you can transfer the captured photos and videos
to a PC. Follow the steps below to connect the camera to a PC.
1. Start a computer to which the Nero software has been installed.
2. Make sure both the camera and PC are turned on.
3. Connect one end of the supplied USB cable to the USB/AV OUT
port on your camera.
4. Connect the other end of the cable to an available USB port on your PC.
5. Disconnect the camera once transfer is completed.