beautypg.com

Troubleshooting guide – Heath Zenith Dual Brite Motion Sensing Coach Light SL-4180/84 - A User Manual

Page 4

background image

TROUBLESHOOTING GUIDE

If you experience a problem, follow this guide. If the problem persists, call the
assistance at 1-800-858-8501 8:00 AM and 4:45 PM EST weekdays.

SYMPTOM

Light will not

come on.

POSSIBLE CAUSE

1. Light switch is turned off.
2. Bulb is loose or burned out.
3. Fuse is blown or circuit

breaker is turned off.

4. Daylight turn-off is in effect

(recheck after dark).

5. Incorrect circuit wiring, if

this is a new installation.

6. Re-aim the sensor to cover

desired area.

Light comes

on in day-
light.

1. Light Control may be in-

stalled in a relatively dark
location.

2. Light Control is in Test.

(Set

control switch to an ON-
TIME position.)

POSSIBLE CAUSE

1. The sensor is pointed at

nearby objects that cause
heat to trigger the sensor.
(Aim the sensor away from
nearby objects.)

2. The sensor is pointed

toward a heat source like
an air vent, dryer vent, or
brightly-painted heat-
reflective surface.

(Re-aim

sensor.)

SYMPTOM

Light stays on

continuously.

Light flashes

on and off.

1. Heat being reflected from

other objects may be
affecting the sensor.

(Re-

aim sensor.)

2. Light Control is in the Test

mode and warming up.
(Flashing is normal under
these conditions).

Light comes

on for no
a p p a r e n t
reason.

1. Light Control may be sens-

ing small animals or automo-
bile traffic

(re-aim sensor).

2. Sensitivity is set too high.

(Reduce sensitivity.)

Lo sentimos, pero no podemos contestar preguntas en español por teléfono.

YOUR HEATH ZENITH FIVE YEAR LIMITED WARRANTY

This is a “Limited Warranty” as defined in the U.S. Consumer Product Warranty and Federal Trade

Commission Improvement Act. This warranty gives you specific legal rights, and you may also have

other rights which vary from state to state.
For a period of five years from the date of purchase, any malfunction caused by factory defective

parts or workmanship will be corrected at no charge to you. Light bulbs are not covered. To obtain

a refund or a replacement, return the product to the place of purchase.
Not Covered — Repair service, adjustment and calibration due to misuse, abuse or negligence,

light bulbs and other expendable items are not covered by this warranty. Unauthorized service or

modification of the product or of any furnished component will void this warranty in its entirety. This

warranty does not include reimbursement for inconvenience, installation, set-up time, loss of use,

or unauthorized service.
This warranty covers only Heath Zenith assembled products and is not extended to other equipment

and components that a customer uses in conjunction with our products.
SUCH REPAIR OR REPLACEMENT SHALL BE THE SOLE REMEDY OF THE CUSTOMER AND

THERE SHALL BE NO LIABILITY ON THE PART OF HEATH FOR ANY SPECIAL, INDIRECT,

INCIDENTAL, OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO ANY

LOSS OF BUSINESS OR PROFITS, WHETHER OR NOT FORESEEABLE. Some states do not

allow the exclusion or limitation of incidental or consequential damages, so the above limitation or

exclusion may not apply to you.