beautypg.com

Heath Zenith High Pressure Sodium Dusk-to-Dawn Security Light SL-5660 User Manual

High pressure sodium dusk- to-dawn security light, Installation instructions, Model sl-5660

background image

High Pressure Sodium Dusk-

to-Dawn Security Light

© 2007 HeathCo LLC

598-1089-03

1. Select a location on a fl at wall with structurally sound wood and

from 10 to 25 feet (3 to 7.6 m) from the ground. The wood should
be at least one inch (25 mm)thick to safely secure the fi xture.

2. Using the mounting template as a guide, mark the 3 mounting holes.

We suggest drilling 3/16" (4.8 mm) pilot holes for the lag screws.

3. Install the two bottom lag screws fi rst. Screw in the lag screws

so that there is about 3/8" (9.5 mm) of space under the head.

4. Place the fi xture on these two screws and install the top lag screw.

Tighten the top lag screw fi rst, then tighten the remaining lag
screws.

5. Secure your outdoor cable or fl exible conduit to the cover plate

with a fi tting in accordance with the National Electrical Code.

6. Thread the black and white fi xture wires through the hole in the

cover plate as shown.

7. Connect the fi xture wires to the service wires (black to black

and white to white).

8. This fi xture must be connected to ground. Secure the service

ground wire under the head of the green ground screw.

9. Install the cover plate. Secure with the two screws and nuts

provided.

10. Install the refl ector/lens assembly. Secure with the two screws

and washers provided.

11. Screw in the 70 watt H.P. Sodium type S62 lamp provided.
12. Loosen the screw in the center of the photocontrol socket two

turns. Twist the socket so that the arrow points north. Note: There
is a stop to prevent the socket from turning all the way around. If
you have trouble turning the socket, try turning it the other direc-
tion. Retighten the screw in the center of the socket.

13. Align the photocontrol (it will only plug-in one way). Plug it in

and twist clockwise until it stops.

Installation Instructions

READ ALL INSTRUCTIONS CAREFULLY BEFORE BEGINNING INSTALLATION.

NOTE: All wiring must be run in accordance with the National Electrical Code (Canadian Electrical Code in Canada) through

conduit or another acceptable means. Contact a qualifi ed electrician if there is any question as to the suitability of
the system.

Ground

Screw

Fixture wires thru

this hole

Photocontrol

Lens/Refl ector

Assembly

Cover Plate

To test operation during daylight, cover the photocontrol with a small box. Turn on the power. Not all photocontrols are alike. Some may
have a time delay of a few minutes, others will turn on as soon as power is applied. The light will take up to ten minutes to reach full
brightness. Uncover the photocontrol and your unit will operate automatically—on at dusk, off at dawn.

Model SL-5660

WARNING: Turn power off at the fuse or circuit

breaker.

Lamp in Fixture Contains Mercury. Dispose According
to Local, State, or Federal Laws.