Harbor Freight Tools 66902 - Manual (Page 4)

SKU 66902 for technical questions, please call 1-800-444-3353. Page 4
with the trigger is dangerous and
must be repaired.
disconnect the tool from the air
d.
source before making adjust-
ments, doing tool maintenance,
clearing jams, touching the safety,
leaving work area, loading, or un-
loading the tool. Such precautionary
measures reduce the risk of injury to
persons.
Store the tool when it is idle out of
e.
reach of children and other un-
trained persons. A tool is dangerous
in the hands of untrained users.
Maintain the tool with care.
f. A prop-
erly maintained tool is more efficient
and reduces the risk of binding and is
easier to control.
check for misalignment or bind-
g.
ing of moving parts, breakage of
parts, and any other condition that
affects the tool’s operation. If dam-
aged, have the tool serviced before
using. Many accidents are caused
by poorly maintained tools. There is a
risk of bursting if the tool is damaged.
use only accessories that are
h.
identified by the manufacturer for
the specific tool model. Use of an
accessory not intended for use with
the specific tool model, increases the
risk of injury to persons.
use only those fasteners listed
i.
in the accessories section of this
manual. Fasteners not identified for
use with this tool by the tool manu-
facturer are able to result in a risk
of injury to persons or tool damage
when used in this tool.
service
Tool service must be performed a.
only by qualified repair personnel.
When servicing a tool, use only
b.
identical replacement parts. use
only authorized parts.
use only the lubricants supplied
c.
with the tool or specified by the
manufacturer.
air source
a. never connect to an air
source that is capable of
exceeding 90 psi. Over
pressurizing the tool may
cause bursting, abnormal operation,
breakage of the tool or serious injury
to persons. Use only clean, dry,
regulated compressed air at the rated
pressure or within the rated pressure
range as marked on the tool. Always
verify prior to using the tool that the
air source has been adjusted to the
rated air pressure or within the rated
air-pressure range.
Never use oxygen, carbon dioxide,
b.
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.
saVe these
instructiOns.