Harbor Freight Tools 66902 - Manual (Page 12)

SKU 66902 for technical questions, please call 1-800-444-3353. Page 12
• Wear ansi-approved safety
goggles with side shields.
Other people in the work area
must also wear ANSI-approved
impact safety goggles.
release the trigger.
•
detach the air supply. •
Attempt to fire the Tool into •
a piece of scrap wood to
ensure that it is disconnected
and is incapable of firing any
fasteners.
empty the magazine and leave •
it open during service. the
Magazine is spring-loaded
and may cause parts or a
fastener to fly out of the Tool.
tO preVent seriOus
injurY frOM tOOl
failure:
do not use damaged
equipment. if abnormal
noise, vibration, or leaking
air occurs, have the problem
corrected before further use.
tO preVent explOsiOn:
Lubricate only with specified
lubricants. lubricate the air
inlet using only pneumatic
tool oil. lubricate the internal
mechanism using only white
lithium grease. Other
lubricants may damage the
mechanism and may be highly
flammable, causing an
explosion.
cleaning, Maintenance, and
lubrication
note: These procedures are in addition to
the regular checks and maintenance
explained as part of the regular op-
eration of the air-operated tool.
daily - air supply Maintenance:
1.
Every day, perform maintenance on
the air supply according to the com-
ponent manufacturers’ instructions.
The lubricator’s oil level needs to be
maintained and the moisture filter
must be regularly drained. Perform-
ing routine maintenance on the air
supply will allow the tool to operate
more safely and will also reduce wear
on the tool.
clearing jams
tO preVent
seriOus injurY
frOM accidental
OperatiOn, BefOre anY
Maintenance Or repairs
are dOne (including clearing
jams):
• Wear ansi-approved safety
goggles with side shields.
Other people in the work area
must also wear ANSI-approved
impact safety goggles.
release the trigger.
•
detach the air supply. •
Attempt to fire Tool into piece •
of scrap wood to ensure
that it is disconnected and
incapable of firing fasteners.
empty the magazine and leave •
it open during service. the
Magazine is spring-loaded
and may cause parts or a
fastener to fly out of the Tool.
If a fastener is jammed in the dis- 1.
charge area, remove it with pliers.
If a fastener is jammed in the maga-
2.
zine, pull the Pusher all the way