Hitachi Koki USA 52 - Manual (Page 16)

1-2
Cha
p
te
r 1
S
a
fe
ty
N
o
te
s
1. Installing the Copier
Installation Site
To ensure utmost safety and prevent possible malfunctions of the copier, install it in a location which
meets the following requirements.
◆ A place away from a curtain or the like that may catch fire and burn easily.
◆ An area where there is no possibility of being splashed with water or other types of liquid.
◆ An area free from direct sunlight.
◆ A place out of the direct air stream of an air conditioner, heater, or ventilator.
◆ A well-ventilated place.
◆ A dry place.
◆ A dust-free location.
◆ An area not subject to undue vibration.
◆ A stable and level location.
◆ A place where ammonia or other organic gas is not generated.
◆ A place which does not put the operator in the direct stream of exhaust from the copier.
◆ A place which is not near any kind of heating device.
Power Source
The power source voltage requirements are as follows:
◆ Use a power source with little voltage fluctuation.
Voltage Fluctuation : Within ± 10%
Frequency Fluctuation : Within ± 0.3%
Space Requirements
To ensure easy copier operation, supply replacements, and service maintenance, adhere to the
recommended space requirements detailed below. Allow a clearance of 6
″
or more at the back of the
copier as there is a ventilation duct.
1155O724AB
111-1/2
81-1/2 9 16-3/4
29 36-3/4 11-1/2
59
-3
/4
45
-3
/4
19-3/4
52
32-1/2
Unit: Inch