Huffy Universal Elevator Mount - Manual (Page 5)

5
10/01 P/N 211125A
19
11
21
17
22
19
20
10
IMPORTANT! Test fit bolts into
holes of brackets (8) and carefully rock
them in a circular motion to ream out
paint from holes if necessary.
IMPORTANT! Finger tighten nuts
and bolts until instructed to fully tighten
later.
Fit spacer (11) into pawl (13) and fit pin
of pawl through end slot of release
lever (12).
IMPORTANT! Bolt (18) must be inserted through tube (17), spacer (19), support bracket (10), board bracket (8),
release lever (12), wave washer (20), and then ratchet (21). Fully tighten all nuts and bolts after assembly.
Use pliers to stretch spring (23) into position.
12
10.
8
10
15
18
23
13
16
6.
7.
8.
9.
10.
14
12
17
9
8