Hitachi 42HDM12A - Manual (Page 9)

8
ACCESSORIES
Check to make sure you have the following accessories before disposing of the packing material.
POWER CORD
2.
D-SUB MINI 15-PIN
CABLE
3.
AUDIO/VIDEO
CABLE
4.
S-VIDEO CABLE
5.
REMOTE
CONTROL
1.
BATTERIES
6.
USER’S GUIDE
7.
EASY GRAPHIC
GUIDE
8.
WARRANTY CARD
9.
REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT
1. Open the battery cover of the remote control by pressing the notched
part of the cover with your fingers and pulling the cover off.
2. Insert two new “AAA” size batteries for the remote control. When
replacing old batteries, push them towards the springs and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery compartment.
4. Replace the cover.
1. Remote Control Unit
2. Power Cord
3. D-SUB Mini 15-Pin Cable
4. Audio/Video Cable
5. S-Video Cables
6. Two “AAA” size, 1.5V batteries
7. User’s Guide
8. Easy Graphic Guide
9. Warranty Card
CAUTION: Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate
ventilation for the electronics or proper support for the front glass panel. This plasma monitor product
is designed for a maximum tilting angle of 45 degrees from vertical.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace with the same or equivalent type.