Hitachi 42HDM12A - Manual (Page 6)

5
E
ngl
ish
França
is
Disconnect the
plug from the
power outlet.
SAFETY INSTRUCTIONS (continued)
Be careful in moving the Plasma Monitor.
Neglect could result in an injury or damage.
• Do not move the PDP monitor during use. Before moving, disconnect the power plug and all external connections.
• You are advised to move the PDP monitor with two persons.
• Avoid any impact or shock to the PDP monitor; particularly take care of glass screen.
Do not put anything on top of the Plasma Monitor.
Placing anything on the PDP monitor could result in loss of balance or falling, and cause an injury or damage. Use special caution in
households where children are present.
Avoid a humid or dusty place.
Placing the PDP monitor in a smoke, a highly humid, dusty place, oily soot or corrosive gas could result in fire or electrical shock.
• Do not place near the kitchen, a humidifier or other place where there is oil, smoke or humidity.
Avoid a high temperature environment.
The heat could have adverse influence on the PDP monitor and other parts, and could result in transformation, melting or fire.
• Do not place the PDP monitor, the remote control and other parts in direct sunlight or near a hot object such as heater, etc.
• Do not put the PDP monitor in a place where the temperature is widely changing.
Remove the power cord for complete separation.
• For safety purposes, disconnect the power cord if the PDP monitor is not to be used for prolonged periods of time.
• Before cleaning, turn off and unplug the PDP monitor. Neglect could result in fire or electrical shock.
• Installation environment
Do not obstruct a ventilation hole.
Do not put the PDP monitor on carpet or blanket, or near a curtain which has a possibility of obstructing a ventilation hole of the PDP monitor.
Do not put the PDP monitor in the following places.
• Hot places such as near heater, place exposed to the direct rays of the sun.
• A place where the temperature is widely changing.
• Places with soot, dust or high humidity.
• Poor air ventilation place.
• Place near fire.
• A wet place such as bathroom, or shower room.
• Place where you can trip over it.
• Always vibrating or strongly vibrating places.
• Distorted or unstable places.
• How to view the Plasma Monitor.
If you use the monitor in too dark a room, your eyes may become tired.
Please use it in a reasonably bright room.
Avoid direct rays of the sun to the screen in order to prevent eye fatigue.
Your eyes will get fatigued after viewing the PDP monitor for long period of time.
Relax your eyes by viewing away from the PDP monitor from time to time.
Please watch the PDP monitor in downward direction.
• How to clean the plasma screen panel of the Plasma Monitor.
Before cleaning the PDP monitor, turn off the monitor and disconnect the power plug from the power outlet.
To prevent scratching or damaging the plasma screen face, do not knock or rub the surface with sharp or hard objects. Clean the screen with a soft cloth
moistened with warm water and dry with a soft cloth. If it is not enough, then use a cloth with mild detergent. Do not use harsh or abrasive cleaners.
• How to clean the cabinet of the Plasma Monitor.
Use a soft cloth to clean the cabinet and control panel of the PDP monitor. When excessively soiled dilute a neutral detergent in water, wet and wring out
the soft cloth and afterward wipe with a dry soft cloth.
Never use acid/alkaline detergent, alcoholic detergent, abrasive cleaner, powder soap, OA cleaner, car wax, glass cleaner, etc. especially because they
would cause discoloration, scratches or cracks.