Hitachi 42HDM12A - Manual (Page 10)

9
E
ngl
ish
França
is
HOW TO SETUP YOUR NEW HITACHI PLASMA MONITOR
To take measures to prevent the Plasma Monitor from tipping over and prevent possible injury it is important to mount the unit
in a stable place.
Securing to a wall
*Keep the Plasma Monitor four inches away from the wall except those hung to the wall mount bracket.
Caution when moving the main unit
As this product is heavy, whenever it is moved, two people are required to transport it safely. Whenever the unit is moved it should be
lifted forward using the top and base on both sides for stability. When moving the Plasma Monitor, lift the top and the bottom frame as
shown below.
LOCATION
Select an area where sunlight or bright indoor illumination will not fall directly on the picture screen. Also, be sure that the location
selected allows a free flow of air to and from the perforated back cover of the set.
To avoid cabinet warping, cabinet color changes, and increased chance of set failure, do not place the monitor where temperatures can
become excessively hot, for example, in direct sunlight or near a heating appliance, etc.
NOTES: 1. Do not block the ventilation holes of the Plasma Monitor. Blocking the ventilation holes might cause fire or defect.
2. If you purchased the wall mount bracket option, please ask for professional installer. Do not install by yourself.
Please avoid installing the monitor directly on the wooden floor. Depending on the quality and condition of the floor,
the desktop stand may stick to the floor face, and the surface could come off when the monitor is lifted up.
PRECAUTIONS