Sntp commands set, X-ring commands set, C-15 sntp commands set – Husky HME-423E User Manual
Page 75: C-16 x-ring commands set
Command Set Lists
C-13
C-15
SNTP Commands Set
Commands
Level Description
Example
sntp enable
G
Enable SNTP function.
switch(config)#sntp enable
sntp daylight
G
Enable daylight saving
time. If SNTP function is
inactive, this command
can’t be applied.
switch(config)#sntp daylight
sntp daylight-period
[Start time] [End time]
G
Set period of daylight
saving time. If SNTP
function is inactive, this
command can’t be
applied.
Parameter format:
[yyyymmdd-hh:mm]
switch(config)# sntp daylight-period
20060101-01:01 20060202-01:01
sntp daylight-offset
[Minute]
G
Set offset of daylight
saving time. If SNTP
function is inactive, this
command can’t be
applied.
switch(config)#sntp daylight-offset 3
sntp ip
[IP]
G
Set SNTP server IP, if
SNTP function is inactive,
this command can’t be
applied.
switch(config)#sntp ip 192.169.1.1
sntp timezone
[Timezone]
G
Set timezone index, use
“show sntp timzezone”
command to get more
information of index
number.
switch(config)#sntp timezone 22
show sntp
P
Show SNTP information.
switch#show sntp
show sntp timezone
P
Show index number of
time zone list.
switch#show sntp timezone
no sntp
G
Disable SNTP function.
switch(config)#no sntp
no sntp daylight
G
Disable daylight saving
time.
switch(config)#no sntp daylight
C-16
X-Ring Commands Set
Commands
Level Description
Example
ring enable
G
Enable X-Ring.
switch(config)#ring enable
ring master
G
Enable Ring Master.
switch(config)#ring master
ring couplering
G
Enable Couple Ring.
switch(config)#ring couplering
ring dualhoming
G
Enable Dual Homing
switch(config)#ring dualhoming
ring ringport
[1st Ring Port] [2nd Ring
Port]
G
Configure 1st/2nd Ring
Port.
switch(config)#ring ringport 7 8
ring couplingport
[Coupling Port]
G
Configure Coupling Port.
switch(config)#ring couplingport 1
ring controlport
[Control Port]
G
Configure Control Port.
switch(config)#ring controlport 2