Hotpoint HDA489 - Manual (Page 4)

How to operate your dishwasher
STEP 1. Load dishwasher STEP 4. Select the and start
●
For RINSE & HOLD
with dishes, pots, dishwasher. Selection
pans, bowls, etc. according to Hints at right.)
a. Be sure door unlatched.
the Loading section. If your dishwasher drains into a
b. Select DRYING HEAT OFF
STEP 2. Add to the food waste disposer, operate the
drying option.
(See Detergent Guide.)
cycle, be careful that you do
Use rinse aid agent to help prevent turn the dial any further than
spotting. Occasionally check to necessary to start the dishwasher.
is at least half full. How to
Use a Rinse Agent section.)
STEP 3. Select DRYING HEAT
option.
detergent sure the disposer it is empty before
Cycle Indicator Dial is at OFF starting the dishwasher.
wATER
SAVER ●
position before adding detergent. To obtain the benefits of a
ON .
OFF ●
●
. RINSE
& HOLO
●
make sure the rinse container
●
For NORMAL WASH cycle:
c. Slowly turn Cycle Indicator Dial
to RINSE & HOLD position.
d. Latch the door to start the cycle.
●
For WARMER
cycle:
a. Load clean plates and dishes to
a. Latch the door
be warmed.
b. turn Indicator Dial
b. Select DRYING HEAT ON.
HEAT ON
HEAT OFF
DRYING HEAT ON. Turns the
drying heater on for fast drying.
DRYING HEAT OFF. Turns the
drying heater off to save energy.
Dishes will dry naturally over a
longer period such as overnight.
If you need your dishes sooner,
open the dishwasher door after the
cycle is complete to reduce the
natural drying time.
Use of this option reduces the
electrical energy used by this
approximately for the
NORMAL WASH cycle.
WATER
SAVER ●
ON .
OFF ● ●
washing
. RINSE
HOLD
●
to to start the cycle.
You will hear the motor start.
There is a time delay between
start-up and water fill so you
will not hear any wash action
right away.
●
For WATER SAVER cycle:
a. Be sure door is unlatched.
b. Slowly turn Cycle Indicator Dial
to WATER SAVER position.
WATER
SAVE
.
OFF ●
. RINSE
&HOLO
●
WATER
SAVER ●
.
OFF ●
washing
●
. RINSE
HOLD
●
c. Leave the door unlatched.
d. Slowly turn Cycle Indicator Dial
clockwise to DRY/PLATE
WARMER position.
e. Latch the door to start the cycle.
c. Latch door to start the cycle.
4