Honeywell HJZTP - Manual (Page 50)

Rev. 1.01 40 900.0570
8-Sept-05
HONEYWELL DIAMOND PROTOCOL, CONTINUED
7.15 ON SCREEN DISPLAY (OSD) MENUS, CONTINUED
For ‘setup’, ‘preshot program’, ‘vectorscan program’ and ‘sector program’, the
programming menu will be displayed as below:
A U X = S E N D A L O C K = E N D
< C A M S C R O L L P R E >
When in the programming menu, on the first display the letter ‘A’ will be flashing to
indicate ‘A’ will be sent to the domes menu when the ‘aux’ key is pressed.
Press the ‘camera’ and ‘preset’ keys to scroll through all available characters.
Pressing the ‘counter’ key will jump the selection between upper case and lower case
letters. If a symbol character is being displayed when the ‘counter’ key is pressed, the
selection will jump to lower case ‘a’.
Press and hold ‘Fn’, then press ’counter’ to jump to symbol characters when letter
characters are being displayed.
Press ‘monitor’ to send ‘BACKSPACE’ to the dome to delete the last character.
Press and hold ‘Fn’, then press ’monitor’ to send the space character. The space
character is also the character between ‘Z’ and ‘a’ when scrolling through the
characters.
Press the number keys to send numbers to the domes menu.
The following keys are also used to control the OSD menus:
Press the ‘F1’ (‘▲’ ) , ’F2’ (‘▼’ ) , ‘F3’ (‘◄’ ) and ‘F4’ (‘►’ ) keys to move around the menu
pages.
Press ‘F5’ (‘enter’) to send ‘ENTER’ to the domes menu.
Press ‘F6’ (‘menu’) to send ‘ESC’ to the domes menu.
Press ‘wash’ to send ‘INSERT’ to the domes to insert a line (in a vectorscan
programming menu).
Press ‘wipe’ to send ‘DELETE’ to the domes to delete a line (in a vectorscan
programming menu).
Press ‘sequence’ to send ‘S’ to the dome (for saving settings).
Press ’aux’ in list menus, to display the next page of items (if available).
Press ‘lock’ to exit the OSD and LCD menus, and return the dome and keyboard to
normal operation.
The keyboard will also shut down the menus if there has been no keyboard activity for
over one minute