Hoover Vacuum Systems - Manual (Page 4)

4
2. Assembling r
Push the wand/tool latch on the hand grip
(A) to the unlock symbol.
Push the hand grip (A) down onto wand so
that the button projection (B) fits into the
slot. Push the latch to the lock symbol to
s e c u re wand.
2-1
A
B
F
C
D
2-2
For metal wands, attach second wand or
tool by fitting button projection (D) on one
into spring latch (C) of first wand. Attach
nozzle in same manner.
To release, press down on center of latch
and remove tool, nozzle, or wand.
2-3
For plastic wands, t u rn plastic latch ring
on wand until outer slot lines up with inner
s l o t .
2-4
Push wand down onto second wand or tool
so that button projection fits into slot. Tu rn
latch ring to lock into place. Reverse pro c e-
d u re to remove wand or tool.
2-5 2-6
Push plug (F) of nozzle power cord com-
pletely into cord receptacle undern e a t h
hand grip.
N OT E : B e fore attaching or remov i n g
nozzle power cord ,a lw ays disconnect
hose power cord (CORDED hose) fro m
electrical outlet or disconnect hose fro m
electrified inlet valve (CORDLESS hose).
Position nozzle power cord into clips on
wands, placing excess cord between noz-
zle and bottom clip.
2-7
2-8
Attach corded hose to
wall inlet valve
After attaching wands and nozzle to hose,
p ress remote control switch on the hand
grip to “OFF.” Open wall inlet valve and
push end of hose firmly into opening.
Push hose power cord plug )G) into an
electrical outlet.
To reduce the risk of electric shock, this
appliance has a polarized plug (one blade
is wider than the other). This plug will fit in
a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a quali-
fied electrician to install the proper outlet.
DO NOT CHANGE THE PLUG IN ANY
WAY.
Unplug hose power cord when finished
cl e a n i n g .
Attach cordless hose
to electrified wall inlet
v a l v e
After attaching wands and nozzle to hose,
p ress remote control switch on the hand
grip to “OFF”. Open electrified wall inlet
valve and push end of hose and mating
pins into opening. Hose is automatically
e n e rgized to operate nozzle.
Unplug hose when finished cl e a n i n g .
G