Tv setup wizard, First time use 13 – Hitachi L42S503 User Manual

Page 13

FIRST TIME USE

TV Setup Wizard

The fifth step will start the scanning feature to find the channels

available on the antenna or cable system. Press the SELECT
button on the remote control to start the channel scan.

The sixth step is the scanning process of the channels, it will first

the scan the analog channels and then the digital channels. The

scanning process will show how many channels have been found.

Please be patient while the scanning process searches for the

available channels in your area. If you wish to cancel the process,
press the SELECT button on the remote control.

Once the user cancels the wizard, the wizard will

•

not be shown again.

If you see the screen above and if you did not

•

connect your Antenna cables to your TV, turn off

your TV, unplug the power cord and connect your

cables according to the applicable connections

in the “First Time Use” section of this Operating

Guide.

After completing the TV Setup Wizard, these

•

screens will not appear again. For updating and

adding the channels available in your area refer to

the Add Channels to List feature on page 39.

The last step is the completion of process, it shows a brief message

and you are ready to view TV programing. This final message will

be shown for a few seconds and then the first detected channel will

be tuned in. You may also press EXIT on the remote control to tune

to the first detected channel.

Your Hitachi LCD television has a TV Setup Wizard feature which has the ability to help you easily setup the first time you turn on your TV

and find the channels available in your area. Please follow the instructions below.

The First time you turn on your Hitachi LCD TV the setup wizard

screen will appear. The first step is to set the language of your TV

On Screen Menu. Select the language that you prefer. Use the p

and

CURSOR to select language and press the SELECT button

on the remote control.

The second and third steps are to set the date and time. There are

two options; one for automatic time setting in which you will select

only the time zone in your area and the second option is a manual

setup for the date and time. Use the CURSOR pad to select and

change the options with the remote control.

The fourth step is designed to find broadcasting or cable

channels. There are two options, Air for an external antenna

and Cable for a cable system provider in your home. Use the

and

CURSOR to select a source and press the SELECT

button on the remote control.

NOTES

Setup Wizard (1/7)

Please select language ...

English

French

Spanish

Cancel

Select

Navigate

SEL

Setup Wizard (2/7)

Please set time mode ...

Auto

Manual

Cancel

Select

Navigate

SEL

Setup Wizard (3/7)

Please select Time Zone ...

NST

AST

Cancel

Select

Navigate

SEL

CST

EST

PST

HST

AKST

MST

Setup Wizard (3/7)

Please enter the date and time ...

Year

Month

Cancel

Select

Navigate

SEL

Time

Date

Jan

12:00 AM

2009

Setup Wizard (4/7)

Please select TV RF tuning band ...

Air

Cancel

Select

Navigate

SEL

Cable

Setup Wizard (5/7)

Please check that the RF cable is

connected properly.

Start

Cancel

Select

Navigate

SEL

Setup Wizard (6/7)

Searching, please wait ...

Searching Analog CH

Channel 3

Cancel

SEL

Analog Channels Found
Digital Channels Found

Cancel

10%

Setup Wizard (7/7)

Exit

EXIT

Congratulations. TV setup is done.