Harbor Freight Tools 45949 - Manual (Page 9)

Page 9 SKU 45949
Maintenance
Warning: Before performing any maintenance you must disconnect power to the Plasma
Cutter and discharge it’s electrode to ground.
1. Regularly clean the Control Filter Receptacle on the rear panel.
2. Clean or replace the nozzle and electrode when they become dirty or worn.
3. Store the Plasma Cutter in a clean and dry location.
Main Parts List
Item # Description
01 Circuit Board C.E. - 22606
02 Rectifier, 35A, 1200V
08 Power Cable
09 Cable Clamp
14 Fan Unit
18 Resistor
21 Circuit Board, C.E. - 22609
23 Changeover Switch
24 Transformer
25 Thermal Cut-out
26 Fan
29 Fixed Wheel
30 Torch Plasma TP 40S
31 Pliers Cable
41 Auxiliary Transformer
42 Handle Tube
46 Solenoid Valve
46.1 Pressure Switch
47 Power Contactor
69 Impedance Coil
70 Fuse Holder
72 Mount
72.1 Mount
84 Pressure Reducer
84.1 Gauge
NOTE: Some parts are listed and shown
for illustration purposes only and are not
available individually as replacement
parts.