HP 6-Port SATA RAID User Manual
Page 8
Installation and configuration procedures 8
13.
On the next screen, respond as follows:
Table 2-1
Entries for array properties
Property line displayed
Entry or selection
Array type
Select the RAID level, and the press the Enter key.
Array label
Type a name, and then press the Enter key.
Array size
Press the Enter key, and then press the Enter key again to use the default granularity of GB.
Stripe size
Press the Enter key.
Read caching
Press the Enter key.
Write caching
Press the Enter key.
Create RAID
Press the Enter key.
[Done] Press
the
Enter key.
A Creating Array window appears.
14.
Press the Enter key to continue with configuration of the array.
NOTE:
You can start using the array immediately. However, performance is reduced until the build
process is complete.
15.
Pres the Esc key until the Exit Utility window appears.
16.
Highlight Yes, and then press the Enter key.
The system restarts.
The server is now ready for the driver to be installed. For details of the procedure, see the website where the
driver is located.