Hitachi VM-H620A - Manual (Page 5)

For Your Safety - 5 -
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Caution to the user: Changes or modifications not expressly approved by the manufacture
could void the user's authority to operate the equipment.
"Note to CATV system installer: This reminder is provided to call the CATV system
installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding
and, in particular, specifies that the cable ground shall be connected to the grounding system
of the building, as close to the point of cable entry as practical".
Notes:
• This unit uses 8mm video format cassettes.
• It records and plays back in the SP mode (14.3 mm/sec).
• It cannot record and play back in the LP mode (7.2 mm/sec).
• This camcorder uses a Hi-Fi stereo sound system. When a tape recorded by this camcorder
is played by a conventional 8mm camcorder, monaural sound is output. When a tape
recorded by a conventional 8mm camcorder is played by this machine, monaural sound is
output.
MOISTURE
Avoid operating your camcorder immediately after moving it from a cold
place to a warm, humid place. Give the camcorder 2 to 3 hours to stabilize
in the ambient conditions of the surroundings before inserting a cassette.
When moved from a cold place to a warm, humid place, moisture may
condense on the head drum inside the machine. This moisture could
cause the tape to stick to the headwheel and damage the headwheel or
tape.
When a small amount of moisture is sensed, "TAPE" flashes in the
viewfinder. Remove the cassette and set the CAM/OFF/VIDEO switch to
OFF, then wait for about one hour.