Hitachi VM-H620A - Manual (Page 44)

Advanced Techniques - 44 -
4. Use the STOP button to place the cursor where you wish to begin your title.
5. Use the F.FWD and REW buttons to select the first character of your title.
6. Once you've selected a character press the STOP button to set it.
7. Complete the title by repeating steps 5 and 6.
8. When you complete your title, press the TITLE ON/OFF button on the remote control to store
the title in memory and remove the title graphics from the viewfinder.
Note: As long as the correct current time can be displayed, the title is held in memory.
Correcting Errors
1. Press the TITLE ON/OFF button on the remote control.
2. Use the STOP button to select the character to be corrected.
3. Use the F.FWD and REW buttons to correct the character.
4. Press the TITLE ON/OFF button on the remote control to store the corrected title in memory.
Recording Title on a Tape in the Camcorder
1. Hold down the red button on the CAM/OFF/VIDEO switch while sliding the switch to CAM.
2. Locate the point of the tape where you wish to record the title ("Using Quick Edit," p.39).
3. Press the TITLE ON/OFF button on the remote control.
4. Press the Start/Stop button to start recording the title.
5. Press the TITLE ON/OFF button on the remote control to stop recording the title. The title
graphics disappear from the viewfinder and the camcorder can record normally.
Note: Create and store your title before an event you plan to record. Just press the TITLE
ON/OFF button on the remote control to superimpose the title over the scene as you record
it. This method avoids erasing previously recorded material which will happen when you
record a title on a previously recorded tape.
Note: Title recording is disabled when you connect the optional AV input cable to the AV
IN/OUT jack to record video and audio from the television or VCR.