Harbor Freight Tools HEAVY-DUTY 1/2" VSR DRILL 3273 - Manual (Page 9)

Page 9 For technical questions, please call 1-800-444-3353. ITEM 3273
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Power Switch/Trigger is in the off-position and unplug the tool
from its electrical outlet before performing any procedure in this section.
Drill Bit Installation
CAUTION! Wear heavy-duty work gloves to provide
protection when inserting and removing drill bits.
Drill bits become very hot during use.
Do not remove drill bits until the bit has cooled.
1. Loosen the Chuck with the Chuck Key until the jaws
of the drill are opened enough to fit the drill bit.
2. Place the desired drill bit or screwdriver bit
into the drill between the Chuck Jaws.
Note: In addition to single or double-ended
screwdriver bits, adapters with hexagonal shafts
with matching socket heads can also be used.
3. Insert the tip of the Chuck Key into a hole on the
side of the Chuck so that the teeth on the Key
engage the gear on the Chuck. Use the Key to
tighten the Chuck securely and remove the Key.
NOTICE: Use sharp bits. Dull, bent, or damaged
bits will cause stress on the drill and/or break.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
SAFETY
OPERA
TION
MAINTENANCE
SETUP