Harbor Freight Tools 99623 - Manual (Page 8)

Page 8 SKU 99623 For technical questions, please call 1-800-444-3353.
rial manufacturer’s recommendation.
To do so, move the Wing Nut (10) to
the proper setting. (See Figure K.)
Grip the Upper Handles (23) with 5.
both hands, pull the Adjust Handle
(6) back and immediately begin
pushing the Spreader at a slow and
even rate over the area you wish to
apply. (See Figure K.)
IMPORTANT: 6. Always PuSH the
Spreader when applying material.
When pulled backward while the
Hopper (16) is open, the Spreader
may apply an excessive amount of
material. (See Figure K.)
When finished applying the material, 7.
push the Adjust Handle (6) forward
to stop the release of material being
applied. (See Figure K.)
FIguRE K
SCREEN
(14)
uPPER HANDLES
(23)
WINg NuT
(10)
HOPPER
(16)
ADJuST HANDLE
(6)
8. Never leave material in the Spreader.
Pour leftover material back into its
bag/container and seal the bag/con-
tainer tightly.
To prevent accidents, wash thor-
9.
oughly to remove all material in the
Spreader. Allow the unit to dry. Then
store the unit indoors out of children’s
reach.
Suggested walking pattern at 10. full rate
settings: (See Figure L.)
FIguRE L
START FINISH
11. Suggested walking pattern at half rate
settings: (See Figure M.)
START
(1ST PASS)
FINISH
(1ST PASS)
START
(2ND PASS)
FINISH
(2ND PASS)
FIguRE M