Hearth and Home Technologies HUDBAY-INS - Manual (Page 28)

Quadra-Fire • Hudson Bay Insert • 7008-115 Rev. H • 10/08 28
A. Glass Replacement
Glass can be replaced either as three separate pieces, or
as an assembly with the door. See Service Parts List.
To Replace Separate Glass Pieces
• Turn off gas to the appliance.
• Remove the door and set on a protective surface.
• Remove the door crown.
• Remove the top and bottom retainer screws from the
front of the door. Set the top and bottom glass retainers
aside.
• Loosen the side glass retainer screws, but do not
remove.
• Remove the glass pieces and discard. Keep the
aluminum channels for reassembly.
• Slide replacement side glass into the side glass
retainers.
• Place the aluminum channels over the side glass.
• Install the center glass into the aluminum channels.
• Reinstall the glass retainers and screws. Reinstall door
crown.
Door Frame with Glass Assembly Replacement
Use only Door Assembly replacement as specifi ed in Sec-
tion 8 of this manual, available from your dealer, if any glass
becomes broken in the Hudson Bay Insert.
Follow the previous instructions to install the door crown
and grille to the new Door Assembly.
11 11
Maintaining and Servicing Appliance
Although the frequency of appliance servicing and maintenance will depend on use and the type of installation, a qualifi ed
service technician should perform an appliance checkup at the beginning of each heating season.
Annual inspection by qualifi ed technician recommended.
Check:
• Condition of glass, glass assembly and glass seal.
• Obstructions of combustion and ventilation air.
• Obstructions of termination cap.
• Burner ignition and operation.
• Burner air shutter adjustment
• Gas connections and fi ttings.
Clean:
• Glass
• Air passageways, grilles,
control
compartment
• Burner, burner ports
Risk of:
• Fire
• Delayed ignition or explosion
• Exposure to combustion fumes
• Odors
Handle glass assembly with care.
NOTE: Clean glass after initial 3-4 hours operation.
Longer operation without cleaning glass may
cause a permanent white fi lm on glass.
CAUTION
When cleaning glass door:
• Avoid striking, scratching or slamming glass.
• Do NOT use abrasive cleaners.
• Use a hard water deposit glass cleaner on white fi lm.
• Do NOT clean glass when hot.
• Turn off appliance after 3-4 hours of operation and
ALLOW TO COOL.
• Remove and clean glass assembly.
• Replace glass assembly and operate appliance for
additional 12 hours.
Refer to maintenance instructions.
Risk of injury or property damage.
Before servicing:
• Turn off gas.
• Turn off electricity to appliance.
• Disable remote control, if one is present.
• Ensure appliance is completely cooled.
After servicing:
• Replace any screen or barrier that was removed.
• Reseal and reinstall any venting removed for servicing.
Inspect external vent cap regularly.
• Ensure no debris blocks cap.
• Combustible materials blocking cap may ignite.
• Restricted air fl ow affects burner operation.
WARNING WARNING
WARNING
Note: The glass and gasketing must be replaced as a
complete unit as supplied by the manufacturer. Do not use
substitute material.