Harbor Freight Tools Chicago 94560 - Manual (Page 3)

Page 3 For technical questions, please call 1‑800‑444‑3353. SKU 94560
ranges and refrigerators. There is an
increased risk of electric shock if your
body is grounded.
do not expose power tools to rain
c.
or wet conditions. Water entering
a power tool will increase the risk of
electric shock.
do not abuse the cord. never use
d.
the cord for carrying, pulling or
unplugging the power tool. Keep
cord away from heat, oil, sharp
edges or moving parts. Damaged
or entangled cords increase the risk of
electric shock.
when operating a power tool
e.
outdoors, use an extension cord
suitable for outdoor use. Use of a
cord suitable for outdoor use reduces
the risk of electric shock.
if operating a power tool in a damp
f.
location is unavoidable, use a
ground Fault Circuit interrupter
(gFCi) protected supply. Use of a
GFCI reduces the risk of electric shock.
personal safety 3.
stay alert, watch what you are a.
doing and use common sense when
operating a power tool. do not use
a power tool while you are tired or
under the influence of drugs, alcohol
or medication. A moment of inattention
while operating power tools may result
in serious personal injury.
use personal protective equipment.
b.
always wear eye protection. Safety
equipment such as dust mask, non-
skid safety shoes, hard hat, or hearing
protection used for appropriate
conditions will reduce personal injuries.
prevent unintentional starting.
c.
ensure the switch is in the off‑
position before connecting to power
source and/or battery pack, picking
up or carrying the tool. Carrying
power tools with your finger on the
switch or energizing power tools that
have the switch on invites accidents.
remove any adjusting key or wrench
d.
before turning the power tool on.
A wrench or a key left attached to a
rotating part of the power tool may result
in personal injury.
do not overreach. Keep proper
e.
footing and balance at all times. This
enables better control of the power tool
in unexpected situations.
dress properly. do not wear loose
f.
clothing or jewelry. Keep your hair,
clothing and gloves away from
moving parts. Loose clothes, jewelry
or long hair can be caught in moving
parts.
if devices are provided for the
g.
connection of dust extraction and
collection facilities, ensure these are
connected and properly used. Use of
these devices can reduce dust-related
hazards.
Only use safety equipment that has
h.
been approved by an appropriate
standards agency. Unapproved
safety equipment may not provide
adequate protection. Eye protection
must be ANSI-approved and breathing
protection must be NIOSH-approved for
the specific hazards in the work area.
power tool use and care 4.
do not force the power tool. use a.
the correct power tool for your
application. The correct power tool will
do the job better and safer at the rate
for which it was designed.
do not use the power tool if the
b.
switch does not turn it on and off.
Any power tool that cannot be controlled