Harbor Freight Tools Chicago 94560 - Manual (Page 11)

Page 11 For technical questions, please call 1‑800‑444‑3353. SKU 94560
work piece and work area set up
Designate a work area that is clean and 1.
well-lit. The work area must not allow
access by children or pets to prevent
distraction and injury.
Route the power cord along a safe
2.
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage. The
power cord must reach the work area
with enough extra length to allow free
movement while working.
Secure loose work pieces using a vise
3.
or clamps (not included) to prevent
movement while working.
There must not be objects, such as utility
4.
lines, nearby that will present a hazard
while working.
general Operating instructions
Plug the Power Cord into the nearest 1.
120 volt, grounded, electrical outlet.
Position the Saw Blade (68, 69) of the
2.
Jigsaw about 1/2” from the beginning cut
line on the workpiece. Do not allow the
Saw Blade to come in contact with the
workpiece.
Turn the Laser Switch (35) to its “ON”
3.
position, and align the laser beam with
the cut line on the workpiece.
Squeeze the Power Switch (29) to turn
4.
on the Jigsaw. If operating the Jigsaw
for an extended period of time, you may
wish to depress the Switch Lock (30)
to lock the Power Switch in its “ON”
position.
Allow the Saw Blade (68, 69) to stroke
5.
at full speed before slowly feeding it into
the workpiece.
Make sure to hold the Jigsaw firmly with
6.
both hands to avoid kickback. Then,
finish making the cut.
When finished, release the Power Switch
7.
(29) to stop the Jigsaw. Wait until the
Saw Blade (68, 69) stops completely.
Turn the Laser Switch (35) to its “OFF”
position. Then, remove the Jigsaw from
the workpiece.
To prevent accidents disconnect the
8.
power cord after use. Clean, then store
the tool indoors out of children’s reach.