Hearth and Home Technologies GBI25 - Manual (Page 12)

26678 Rev H 12 02-02
GBI25 SERIES B-VENT GAS FIRED FIREPLACE INSERT
4. WIRING
a. A 110V AC outlet should be located close to the
lower left side of the appliance to allow the fan to
be plugged in. See Figure 24.
Figure 24 - Wiring Diagram
Note: This appliance REQUIRES a 110V AC
supply for operation of the fan.
Note: This appliance must be electrically wired and
grounded in accordance with local codes or, in the ab-
sence of local codes, with National Electric Code ANSI/
NFPA 70-latest edition. This appliance can be used with
a thermostat.
CAUTION:
Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and danger-
ous operation. Verify proper operation after servicing.
WARNING!
Do not use this appliance if any part has been under water. Immediately call a qualified
service technician to inspect the appliance and to replace any part of the control sys-
tem and any gas control which has been under water.