Hobart Welding Products OM-1594 - Manual (Page 21)

OM-1594 Page 17
4-5. Water-Cooled Gun Connections
Ref. 801 577-A / 801 563 / Ref. 151 666-A
1 Gun Control Cable
Insert plug into Gun Control
receptacle, and tighten threaded
collar.
2 Gas Hose
3 Reed Relay
4 Weld Cable
5 Weld Cable Terminal In
Feeder
Route weld cable from welding
power source through reed relay to
weld cable terminal in feeder and
connect to weld cable terminal.
6 Gun Connector
7 Gun Securing Knob
8 Gun Connector Block
Loosen gun securing knob, and
insert gun connector through Wire
opening until it bottoms against
block. Tighten knob. Close and
latch door.
9 Water In Hose
Connect to Water In fitting on feeder
(left-hand threads).
10 Water Out Hose
Connect to Water Out fitting on
feeder (left-hand threads)
Close and latch door.
Tools Needed:
1
9
10
5 4
8
7
6
2
Left Side
3
1
9
10
9/16 in