Harbor Freight Tools CENTRAL MACHINERY 65345 - Manual (Page 8)

Page 8 SKU 65345 For technical questions, please call 1-800-444-3353.
least the minimum wire size required.
(See Table A.)
If you are using one extension cord
4.
for more than one tool, add the
nameplate amperes and use the sum
to determine the required minimum
cord size. (See Table A.)
If you are using an extension cord 5.
outdoors, make sure it is marked with
the suffix “W-A” (“W” in Canada) to
indicate it is acceptable for outdoor
use.
Make sure the extension cord is prop-
6.
erly wired and in good electrical con-
dition. Always replace a damaged
extension cord or have it repaired by
a qualified electrician before using it.
Protect the extension cords from
7.
sharp objects, excessive heat, and
damp or wet areas.
rEcOMMENDED MINIMuM WIrE
gAugE FOr EXTENSION cOrDS*
(110 VOLT)
NAMEpLATE
AMpErES
(at full load)
EXTENSION cOrD
LENgTH
25’ 50’ 75’
100’ 150’
0 – 2.0 18 18 18 18 16
2.1 – 3.4 18 18 18 16 14
3.5 – 5.0 18 18 16 14 12
5.1 – 7.0 18 16 14 12 12
7.1 – 12.0 18 14 12 10 -
12.1 – 16.0 14 12 10 - -
16.1 – 20.0 12 10 - - -
TABLE A
* Based on limiting the line
voltage drop to five volts at
150% of the rated amperes.
SYMBOLOgY
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
V~
Volts Alternating Current
A
Amperes
n0 xxxx/min.
No Load Revolutions per Minute
(RPM)
SpEcIFIcATIONS
Electrical
Requirements
110 V~ / 60 Hz
Power Cord: 18 AWG X 3C
Power Plug: 3-Prong, Grounded
7.5 A
Maximum Stock
Length/Diameter
18” Long, 10” Diameter
Lathe Type Wood Cutting
Motor 1/2 HP
Motor Speed 1700 RPM
Spindle Speeds
(RPM)
750, 1100, 1600, 2200, 3200
Spindle Run Out 0.0025”
Tail Stock
Quill Travel
2”
Tail Stock
Quill Taper
MT-2
Tool Rest Length 7”
Tool Rest Capacity 2”
Faceplate Size
3”
Drive Method Belt & Pulley
Belt Type 3-Groove, 0.275” x 2’1” Circumference
Accessories
Safety Goggles (Qty. 1)
3mm, 6mm, 8mm Hex Wrench (1 ea.)
Faceplate & Spindle Nut (1 ea.)
Live Center & Spur Center (1 ea.)
Tool Rest (Qty. 1)
rEV 09e