Hoover S1055 - Manual (Page 13)

Secondary filter
The secondary filter protects the
motor from dirt particles. It is
located at the front of the bag com-
partment. When bag is removed,
check filter, which is not remov-
able. If filter is dirty, remove dirt
with a small brush.
Rug/f nozzle
Replacing brush
Replace the brush on the rug and
floor nozzle when it becomes worn
and is not doing a satisfactory job
of cleaning. Brush Lock Lever
must be in “RUG” position to
remove brush.
1. Remove one of the metal clips
holding brush in position by placing
a screwdriver under the raised edge
and lifting upward. Note position
of old brush and springs, then
remove them.
2. Screw springs onto projections
of new brush. Center new brush in
nozzle. Make sure that the bristles
are facing up and the projection
side is turned toward tube. Replace
the clip and clamp into position by
pressing down with the flat side of
a screwdriver.
12